Odour Control Nozzle Selection Table
The table below summarizes much of the information in the odour control nozzle section of the BETE Limited website. It is intended to be handy reference guide to aid nozzle selection. Full data on each of the nozzles listed can be accessed by clicking on the boxes in the left hand column of the table below.
| Nozzle Type | Design Type | Notes | Ability to cope with wind | Flow rates
(litres / minute) | Minimum Operating Pressure
|
| 
| Misting Small orifice | Will require filter | Very Poor | 0.03 - 0.52 | 7 BAR |
| 
| Misting Small orifice | Will require filter | Very Poor | 4.2 - 8.7 | 70 BAR
|
| 
| Misting Small orifice | Built in filter system | Poor | 1.5 - 61.1 | 3 BAR
|
| 
| Misting Impingement | Low flow rate impingement nozzle | Poor | 0.03 - 5.3 | 2 BAR
|
| 
| Misting Impingement | | Poor | 0.15 - 30.3 | 1 BAR
|
| 
| Full cone Air atomising | Low flow rates Requires compressed air supply Air helps project spray | Average | 0.025 - 1.83 | 0.7 BAR
|
| 
| Spiral full cone | Higher flow rates | Good | 0.53 - 14.7 | 0.7 BAR
|